Firmware installer
Plug the device in over USB and click Install. Works in Chrome and Edge on desktop.
This browser cannot flash firmware.
You need Chrome or Edge on a desktop computer. The Živý obraz links work here as well.
How it works
- Connect the device with a data USB cable — charge-only cables will not work.
- Click Install next to your device.
- Pick the serial port the browser asks for and confirm.
- Wait for it to finish. The device then restarts on its own.
SVERIO devices
BuzerKostka
ESP32-S3
RGB status cube with MQTT and Home Assistant.
Full install
v1.0.0
Chrome or Edge required
HTTPS required
After flashing the device restarts and creates its own Wi-Fi network for initial setup.
BuzerPopelnice (Kterou.cz / Binday.eu)
ESP32-S3
Light-up reminder of which bin to put out.
Full install
v1.1.0
Chrome or Edge required
HTTPS required
After flashing the device restarts and creates its own Wi-Fi network for initial setup. Holding the button during boot clears the stored Wi-Fi credentials.
BuzerDisplej
ESP32-S3
Display for sensor readings and weather stations.
Full install
v1.5
Chrome or Edge required
HTTPS required
expLORA Gateway LITE
ESP32-S3
LoRa gateway collecting data from wireless sensors.
Update
v1.1.13
Chrome or Edge required
HTTPS required
Keeps your settings. Requires the device to be running at least version 1.1.0.
Clean reinstall
v1.1.13
Chrome or Edge required
HTTPS required
A clean reinstall erases all stored settings and the device has to be set up again from scratch. Use it only if the device runs a version older than 1.1.0, or if the update failed.
einkLink
einkLink
ESP32-S3 · 16 MB flash
Prusa Connect print monitor. Web interface is flashed too.
Black & white 5.83" · 648×480 · GDEW0583T8
v0.5.18-prusa
Chrome or Edge required
HTTPS required
Black & white 7.5" · 800×480 · GDEY075T7
v0.5.18-prusa
Chrome or Edge required
HTTPS required
Debug builds
Black & white 5.83" — debug build
v0.5.18-prusa
Chrome or Edge required
HTTPS required
Verbose serial output and failure detail shown on the display.
Black & white 7.5" — debug build
v0.5.18-prusa
Chrome or Edge required
HTTPS required
Verbose serial output and failure detail shown on the display.
Živý obraz
PaperBoard
ESP32-S3
E-ink display, 6" and 9.7" versions.
If your computer does not see the device after plugging in USB, briefly press the RESET button on the back and try again.
Firmware for both 6" and 9.7"
zivyobraz.eu
In the wizard pick manufacturer Pájeníčko, then PaperBoard.
CrowPanel
ESP32-S3
E-ink panel, 2.13", 4.2" and 5.79" versions.
Firmware for all sizes
zivyobraz.eu
In the wizard pick manufacturer Pájeníčko, then CrowPanel.
No device matches your search.